Wood saving from 10 to 20%
The Woodchip Saver or Pellet Saver is a sticker a few centimeters long and wide, which is stuck on the conveyor shaft or on the storage box of the wood. It increases the burning efficiency of the wood or pellets/chips.
The sticker acts as an information carrier and changes the molecular structure of the wood, thus optimizing the combustion process for all types of wood. The sticker is a vibration carrier that energizes the wood in such a way that it is broken down into ionized gas chains during combustion, resulting in improved combustion and thus less toxic exhaust gases. So to speak "homeopathy for your wood".
Example: click here!
In the case of wood, we are dealing with long-chain hydrocarbons, which not only contain C-H bonds but also C-C (shown in black) bonds. At the C-C bonds can not attach oxygen O can attach to the C-C bonds, so these bonds are found in the exhaust gas as soot (carbon). The "Woodchip-Saver" splits the C-C bonds in the fuel and the two C-atoms can now form additional bonds with the oxygen O in the ambient air.
The additional bonds with the oxygen O lead to an increased gas content and therefore increase the combustion performance of the wood.
Change in wood (pellets, logs. etc) after 1 week
Hello Mr. Renner,
I was with Knut Erdtmann and together we burned both the untreated and treated wood in his heating System.
Material:
sawn disposable pallet, i.e. pine board, same length - width u. height. The difference was significant! The n-g treated wood (WS-Saver applied to all 5 sides of the box) burned much longer and with a high proportion of blue flames after 7 days in the box.
When no more flames came out of the untreated wood, but only embers were present, the treated board on the other side of the combustion chamber burned approximately only half of the material.
We then repeated the test several times in reverse to rule out the possibility that the improved burning effect was caused by draught, more initial embers or similar. However, the result remained the same.
Further results of the wood saver:
- 1/3 less ash
- not as "dusty" as before
- Smoke and odor formation is reduced
The nails and staples are now metallically pure (which in my opinion indicates a hotter flame, or combustion). They can be effortlessly removed from the ash with a magnet, without -as before- ash sticking to them.
Norbert Hammer
Auf der Hausstelle 58
21403 Wendisch Evern b. Lüneburg
Affected wood burned 8% longer, yielded 4% more heat.
Wood influenced with Bio Energetic wood saver burned 8% longer, yielded 4% more heat and 18% less ash.
Documentation Bio Energetic wood saver test:
Küenzel wood gasifier 30 KW, 1700 liters of water storage.
Wood : 32 kg hardwood and 4 kg softwood, total 36 kg wood
WITHOUT Bio Energetic wood saver:
Sat, 10/27/2012 Burning approx. 4h 50m, temperature rise approx. 50 degrees, approx. 226 gr. Ash
WITH Bio Energetic wood saver (2 plates wh 7).
Sat, 10.11.2012 burn down approx. 5h 14m, temperature rise approx. 52 degrees, approx. 185 gr. Ash
8,2% longer 4% heating gain 18% less ash
The flue gas test (CO2 content, carbon monoxide, hydrocarbons) over several hours could not be realized by the chimney sweep.
Best regards
Stefan Erzinger
st.erzinger@sunrise.ch
